Microsoft Windows XP [Version 5.1.2600] (C) Copyright 1986-2001 Microsoft Corp. C:\WINDOWS>netsh routing ip ospf set interface ?
Usage: set interface [name=] interface name
[[addr=][mask=]][[state=]enable|disable][[areaid=]][[type=]nbma|p2p|broadcast][[prio=]<0-255>][[transdelay=]][[retrans=]][[hello=]][[dead=]][[poll=]][[metric=] metric][[password=]][[mtu=]]
Parameters:
Tag Value
name - The name of the interface.
addr - IP address of the interface.
mask - IP address mask of the interface.
state - One of the following values:
enable: enables the interface.
disable: disables the interface.
areaid - The IP address of the interface area.
type - One of the following values:
nbma: a non-broadcast multiple access (NBMA) OSPF
interface.
p2p: a point-to-point OSPF interface.
broadcast: a broadcast OSPF interface.
prio - Interface priority.
transdelay - The estimated number of seconds it takes to transmit a
link state update packet over this interface.
The default setting is 1 second.
retrans - The number of seconds between link state advertisement
retransmissions for adjacencies belonging to this
interface. A sample value for a local area network is
5 seconds.
hello - The interval in seconds between transmissions of hello
packets by the router on the interface. This setting
must be the same for all routers that are attached to a
common network. A sample value for a local area network
is 10 seconds.
dead - The number of seconds before a neighboring router
considers this router to be down. This setting should
be an integral multiple of the hello interval
(commonly 4). This value must be the same for all OSPF
router interfaces attached to a common network segment.
poll - The number of seconds between OSPF network polls for
non-broadcast multiple access (NBMA) interfaces only.
You should set the poll interval to be at least twice
as long as the dead interval. A sample value for an X.25
network is 2 minutes.
metric - The cost of sending a packet out of this interface.
The value set here is advertised as the link cost for
this interface in the link state advertisement of the
router. Faster interfaces usually have lower costs.
The maximum setting is 32,767.
password - If passwords are enabled for the area (the default
setting) the password used for this interface.
All interfaces in the same area that are on the same
network must use identical passwords.
By default, passwords are enabled and the password is
12345678.
mtu - The maximum size in bytes of IP packets carrying OSPF
information that can be sent without
fragmentation. The default value of 1,500 bytes is the
default IP MTU for an Ethernet network.
Remarks: Changes OSPF configuration parameters for the interface.
Examples:
set interface "Local Area Connection" 10.0.0.1 255.0.0.0 metric=2 mtu=1500
